Round 3 Guides
Below are links to guides produced by David Price that will be helpful to R3 builders. This page will be changed as more info becomes available.
All the printed parts should be checked for hole size and some prints may have undersize holes (better than oversize), some printers may have eased or fettled the holes for you, but others leave it to the builder to do, to get the best fit as the rods do vary by microns in size. The barclamp teardrop only allows a small amount of compression, and the bar need to be held firmly, so good sizing is important.
Regarding the barclamps: It is important to clip onto the threaded rod before inserting the rod into the teardrop.
|TVRR Prusa part 0 v1.0.pdf||986.69 KB|
|TVRR Prusa part 1 v1.1.pdf||1.04 MB|
|TVRR Prusa part 2 v1.2.pdf||1.22 MB|
|TVRR Prusa part 3 v1.2.pdf||1.29 MB|
|TVRR Prusa part 4 v1.1.pdf||1.2 MB|
|TVRR Prusa part 5 v1.1.pdf||1.14 MB|
|TVRR Prusa part 6 v1.2.pdf||3.41 MB|
|TVRR Prusa part 7 v1.2.pdf||3.3 MB|
|TVRR Prusa part 8 v1.0.pdf||2.68 MB|
|TVRR Prusa part 9 v1.0.pdf||2.48 MB|